CanMore Sport-Guide Mate Bedienungshandbuch PDF herunterladen (Seite 556)

100

101

NOTE: Sealant may leak out through the puncture in the

tire.

If the sealant (white fluid) does not flow within0–10

seconds through the Sealant Hose (6):

1. Press the Power Button (4) to turn Off the TIREFIT kit.

Disconnect the Sealant Hose (6) from the valve stem.

Make sure the valve stem is free of debris. Reconnect

the Sealant Hose (6) to the valve stem. Check that the

Mode Select Knob (5) is in the Sealant Mode position

and not Air Mode. Press the Power Button (4) to turn

On the TIREFIT kit.

2. Connect the Power Plug (8) to a different 12 Volt

power outlet in your vehicle or another vehicle, if

available. Make sure the engine is running before

turning ON the TIREFIT kit.

3. The Sealant Bottle (1) may be empty due to previous

use. Call for assistance.

NOTE: If the Mode Select Knob (5) is on Air Mode and

the pump is operating, air will dispense from the Air

Pump Hose (7) only, not the Sealant Hose (6).

If the sealant (white fluid) does flow through the

Sealant Hose (6):

1. Continue to operate the pump until sealant is no

longer flowing through hose (typically takes 30 - 70

seconds). As the sealant flows through the Sealant

Hose (6), the Pressure Gauge (3) can read as high as 70

psi (5 Bar). The Pressure Gauge (3) will decrease

quickly from approximately 70 psi (5 Bar) to the actual

tire pressure when the Sealant Bottle (1) is empty.

2. The pump will start to inject air into the tire immedi-

ately after the Sealant Bottle (1) is empty. Continue to

operate the pump and inflate the tire to the pressure

indicated on the tire pressure label on the driver-side

latch pillar (recommended pressure). Check the tire

pressure by looking at the Pressure Gauge (3).

554 WHAT TO DO IN EMERGENCIES

1 2 ... 551 552 553 554 555 556 557 558 559 560 561 ... 682 683

Kommentare zu diesen Handbüchern

Keine Kommentare

CanMore Sport-Guide Mate Bedienungshandbuch Seite 556

Kommentare zu diesen Handbüchern