CanMore Sport-Guide Mate Bedienungshandbuch PDF herunterladen (Seite 282)

100

101

• To program the remaining two HomeLink® buttons,

repeat each step for each remaining button. DO NOT

erase the channels.

Reprogramming A Single HomeLink® Button

To reprogram a channel that has been previously trained,

follow these steps:

1. Cycle the ignition to the ON/RUN position.

2. Press and hold the desired HomeLink® button until

the indicator light begins to flash after 20 seconds. Do

not release the button.

3. Without releasing the button proceed with “Program-

ming A Non-Rolling Code” Step 2 and follow all

remaining steps.

Canadian/Gate Operator Programming

For programming transmitters in Canada/United States

that require the transmitter signals to “time-out” after

several seconds of transmission.

Canadian radio frequency laws require transmitter sig-

nals to time-out (or quit) after several seconds of trans-

mission – which may not be long enough for HomeLink®

to pick up the signal during programming. Similar to this

Canadian law, some U.S. gate operators are designed to

time-out in the same manner.

It may be helpful to unplug the device during the cycling

process to prevent possible overheating of the garage

door or gate motor.

1. Cycle the ignition to the ON/RUN position.

280 UNDERSTANDING THE FEATURES OF YOUR VEHICLE

1 2 ... 277 278 279 280 281 282 283 284 285 286 287 ... 682 683

Kommentare zu diesen Handbüchern

Keine Kommentare

CanMore Sport-Guide Mate Bedienungshandbuch Seite 282

Kommentare zu diesen Handbüchern