CanMore Sport-Guide Mate Bedienungshandbuch PDF herunterladen (Seite 280)

100

101

2. Place the hand-held transmitter 1 to 3 in (3 to 8 cm)

away from the HomeLink® button you wish to pro-

gram while keeping the HomeLink® indicator light in

view.

3. Simultaneously press and hold both the HomeLink®

button you want to program and the hand-held trans-

mitter button.

4. Continue to hold both buttons and observe the indi-

cator light. The HomeLink® indicator will flash slowly

and then rapidly after HomeLink® has received the

frequency signal from the hand-held transmitter. Re-

lease both buttons after the indicator light changes

from slow to rapid.

5. At the garage door opener motor (in the garage),

locate the “LEARN” or “TRAINING” button. This can

usually be found where the hanging antenna wire is

attached to the garage door opener/device motor.

Firmly press and release the “LEARN” or “TRAIN-

ING” button. On some garage door openers/devices

there may be a light that blinks when the garage door

opener/device is in the LEARN/TRAIN mode.

NOTE: You have 30 seconds in which to initiate the next

step after the LEARN button has been pressed.

6. Return to the vehicle and press the programmed

HomeLink® button twice (holding the button for two

seconds each time). If the garage door opener/device

activates, programming is complete.

NOTE: If the garage door opener/device does not acti-

vate, press the button a third time (for two seconds) to

complete the training.

To program the remaining two HomeLink® buttons,

repeat each step for each remaining button. DO NOT

erase the channels.

278 UNDERSTANDING THE FEATURES OF YOUR VEHICLE

1 2 ... 275 276 277 278 279 280 281 282 283 284 285 ... 682 683

Kommentare zu diesen Handbüchern

Keine Kommentare

CanMore Sport-Guide Mate Bedienungshandbuch Seite 280

Kommentare zu diesen Handbüchern